Description; Tools And Accessories - Hilti TE 2-A Original Operating Instructions

Location of identification data on the tool
The type designation, item number, year of manufacture
and technical status can be found on the rating plate on
the tool. The serial number is located on the left side of
the motor housing. Make a note of this data in your ope r-
ating instructions and always refer to it when making an
enquiry to your Hilti representative or service depart-
ment.
en

2. Description

The TE 2-A is a cordless rotary hammer for profession-
al use. Its ergonomically designed rubber-padded grip
reduces fatigue and provides a secure hold.
The items supplied include:
- The electric tool
- B24/2.0 NiCd, B24/2.4 NiCd or B24/3.0 NiMH battery
- C 7/24 or C 7/36-ACS charger
- Operating instructions
- Toolbox or cardboard box
2.1 Use of the tool as directed
The TE 2-A is a hand-held cordless rotary hammer for
driving and removing screws, drilling in steel, wood and
masonry and hammer drilling in concrete and mason-
ry. It is intended for use on construction sites of all kinds
for general construction, interior finishing, conversion
and renovation work.
The tool is designed for continuous use.
●
The tool may be used only in a dry environment.
●
Do not use the tool where there is a risk of fire or explo-
●
sion.
Use only the insert tools and accessories intended for
●
use with this tool.
The tool may be powered only by the batteries approved
●
for use with this tool.
The batteries are to be used exclusively to power tools
●
of the Hilti 24 V line.
Use only the recommended battery charger.
●
Modification or manipulation of the tool other than
●

3. Tools and accessories

Side handle and depth gauge
Grease
Cleaning cloth
Charger
Charger
Charger
Battery
Battery
Battery
Toolbox/cardboard box
Belt adaptor
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5137393 / 000 / 00
Type:
Serial no.:
described in these operating instructions is not per-
missible.
To avoid the risk of injury, use only original Hilti acces-
●
sories and additional equipment.
Observe the information printed in the operating instruc-
●
tions concerning operation, care and maintenance.
The tool and its ancillary equipment may present ha -
●
zards when used incorrectly by untrained personnel
or when used not as directed.
2.2 Requirements to be met by users
The tool is intended for professional use.
●
The tool may be operated, serviced and repaired only
●
by authorized, trained personnel. This personnel must
be informed of any special hazards that may be encoun-
tered.
Always concentrate on the job you are doing. Proceed
●
carefully and do not use the tool if your full attention
is not on the job.
2.3 Important features of the tool
– Vibration-absorbing grip (rubber-padded)
– Smooth speed control
– Gearing and clutch with permanent lubrication
(grease)
– Automatic cut-out carbon brushes
– Forward / reverse rotation
– Function selector switch for rotary drilling/hammer
drilling
Optional
Optional
Optional
C 7/24
C 7/36-ACS
TCU 7/36
B24/2.0 NiCd (depending on country)
B24/2.4 NiCd (depending on country)
B24/3.0 NiMH
BAP 24