Panasonic CS-CE9JKE Operating Instructions Manual page 5

TO TURN ON OR OFF THE
UNIT
• Please be aware of the OFF indication on the remote
control display to prevent the unit from starting/
stopping improperly.
TO SET TEMPERATURE
• Selection range: 16°C ~ 30°C (Not applicable for FAN
mode).
• Operating the unit within the recommended
temperature could induce energy saving.
HEAT mode : 20˚C ~ 24˚C.
COOL mode : 26˚C ~ 28˚C.
DRY mode : 1˚C ~ 2˚C lower than room temperature.
TO SELECT OPERATION MODE
AUTO mode - For your convenience
• Unit selects operation mode every 30 minutes
according to temperature setting, outdoor and room
temperature. During operation mode selection the
power indicator blinks.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power indicator
blinks during this operation.
COOL mode - To enjoy cool air
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
FAN mode - To circulate air in the room
TO SELECT FAN SPEED
(5 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing up/down
automatically.
• In heat mode, the air blows horizontally for a while,
then starts to blow downwards.
TO SET THE TIMER TO SET THE TIMER
POWER
• To turn ON or OFF the unit at a preset time.
Select ON or
OFF timer.
• To cancel ON or OFF timer, press
press
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
OPTIONAL SETTINGS OPTIONAL SETTINGS
Press and hold for 5 seconds to dim or
restore the unit's indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
CLOCK
indication.
Press to restore the remote control's default
setting.
Not used in normal operations.
,
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
Set the time.
.
.
TIMER
Confi rm.
or then
5