Adjusting The Clutch Lever - Sachs Bikes MadAss 50 Owner's Manual

NOTES ON MAINTENANCE
Adjusting the clutch lever 4-gear model
2
A
3
1
CAUTION
If you drive with no clutch lever play, the
clutch will be damaged.
Check:
- Pull the lever until there is discernable
resistance.
- Measure the play. Required value:
A = min. 3-4 mm
Adjustment:
- Push back protective cap (1).
- Release the lock nut (2).
- Turn setting screw (3) as appropriate.
- Tighten up the lock nut (2).
- Check the play.
50
5
4
NOTE
If the clutch play cannot be corrected with
this adjustment, the following adjustment
must be made.
- Release the lock nut (2).
- Tighten setting screw (3) all the way, so
that the clutch cable can be made as slack
as possible.
7
6
- Tighten up the lock nut (2).
- Remove screws (4) and take off the clutch
cover (5).
- Release the lock nut (6).
- Adjust the setting screw (7) until the
desired clutch lever play (A = 3-4 mm) is
reached.
- Tighten up the lock nut (6).
- Reassemble the clutch cover (5) with
gasket.
CAUTION
Have adjustment checked by a SFM
dealer.