Table of Contents
Advertisement
current drive capability
current sinking
current sourcing
D
D/A
DAC
daisy-chain
DAQ
dB
DC
DC coupled
default setting
© National Instruments Corporation
the amount of current a digital or analog output channel is capable of
sourcing or sinking while still operating within voltage range specifications
the ability of a DAQ board to dissipate current for analog or digital output
signals
the ability of a DAQ board to supply current for analog or digital output
signals
digital-to-analog
digital-to-analog converter—an electronic device, often an integrated
circuit, that converts a digital number into a corresponding analog voltage
or current
a method of propagating signals along a bus, in which the devices are
prioritized on the basis of their position on the bus
data acquisition—(1) collecting and measuring electrical signals from
sensors, transducers, and test probes or fixtures and inputting them to a
computer for processing; (2) collecting and measuring the same kinds of
electrical signals with A/D and/or DIO boards plugged into a computer, and
possibly generating control signals with D/A and/or DIO boards in the
same computer
decibel—the unit for expressing a logarithmic measure of the ratio of two
signal levels: dB=20log
direct current
allowing the transmission of both AC and DC signals
a default parameter value recorded in the driver. In many cases, the default
input of a control is a certain value (often 0) that means use the current
default setting. For example, the default input for a parameter may be do
not change current setting, and the default setting may be no AMUX-64T
boards. If you do change the value of such a parameter, the new value
becomes the new setting. You can set default settings for some parameters
in the configuration utility or manually using switches located on the
device.
(V
/V
), for signals in volts
10
1
2
G-5
Glossary
PCI-4451/4452 User Manual
Advertisement
Table of Contents
