Maintenance; Plug Replacement; Environmental Protection - Worx WG151E Manual

Release line from cleat and feed line through
eyelet.
Refit the cap.
TO FIT NyLON LINE ONLy:
wARNINg! Take approximately 10ft
(3 m) of line. Insert 2/5" (10mm ) of
line into the spool holes and wind line in the
direction of the arrows on the top of the spool.
Your Trimmer is designed to use only line with
a maximum diameter of 1.65mm"
IMPORTANT: Leave approximately 4"
(100mm) of line unwound and place into cleat.
Care should be taken to ensure that the line
is neatly coiled on the spool. Failure to do so
will impair the efficiency of the automatic line
feed.
Then fit spool as described in "To fit spool
and line complete".

MAINTENANCE

After use, disconnect the battery from
the mains and check for damage.
Your power tool requires no additional
16 16
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
2-in-1 cordless Li-ion grass trimmer/edger

PLUG REPLACEMENT

If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
blue = Neutral
brown = Live
As the colors of the wires in the electrical cord
of this appliance may not correspond with the
colored markings identifying the terminals
in your plug, proceed as follows. The wire
which is colored blue must be connected to
the terminal which is marked with N. The wire
which is colored brown must be connected to
the terminal which is marked with L.
wARNINg! Never connect live or
neutral wires to the earth terminal of the
plug. Only fit an approved 13Amp BS1363/A
plug and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
13
EN