Operation - Worx WG151E Manual

OPERATION

wARNINg! Always wear the eye
protection. Never lean over the
trimmer head. Rocks or debris can ricochet
or be thrown into eyes and face and cause
blindness or other serious injury. When
operating unit, check for the following:
Wear eye protection and heavy clothing. Hold
front handle with one hand and auxiliary
handle with the other hand. Keep unit below
waist level. Work only from your right to your
left to ensure debris is thrown away from you.
Without bending over, keep line near and
parallel to the ground (perpendicular when
edging) and not crowded into material being
cut.
wARNINg! Make sure that line is
fed out before operation. Make
sure motor is up to full speed before
trimming.
wARNINg! Use only 1.65mm cutting
line, diameter line. Other sizes of
line will not feed properly and will result in
improper cutting head function or can cause
serious injury. Do not use other material
such as wire, string, rope, etc. Wire can break
off during cutting and become a dangerous
missile that can cause serious injury.
TRIMMINg
Hold the bottom of the trimmer head about 8
cm above the ground and at an angle. Allow
only the tip of line to make contact. Do not
force trimmer line into work area.
EDgINg (See Fig L)
Holding the lower housing then pull upwards
the shaft, then rotate 90 degree clockwise. (Fig
H1)
Adjust trimmer head angle to be the lowest
horizontal setting. Then position the wheel on
the ground for edge mode. The guard has two
white line guides to indicate the cutting line
position. Align these marks with the edge of
your lawn.
While edging, allow the tip of the line to make
contact. Do not force the line. The rotation
wheel helps protect the unit and keeps the
unit from contacting the ground. Take extra
caution while edging as objects can be thrown
from the trimmer line.
2-in-1 cordless Li-ion grass trimmer/edger
AuTOMATIC LINE FEED SySTEM
When initially switching on the trimmer, a
small length of line is fed out.
A 'clattering' noise will be heard when the
lines hit the line cutter. DO NOT BE ALARMED
this is quit normal. After about 5 seconds the
line will be cut to the correct length and the
noise will reduce as the motor receives full
speed.
If the noise of the line being cut can't be
heard, more line will be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
TO MANuALLy FEED THE LINE (See Fig
M1)
If required, line can be feed out manually
To operate, press and release manual line feed
button (16), while gently pulling out the line
until the lines reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
TO REMOVE THE CAP (See Fig M2)
Press and hold in the two latches (12).
Pull cap away from the spool holder
When refitting the spool cap.
Keep all areas of the cap and spool holder
clean.
Replace the cap, pressing firmly down
towards the spool holder to ensure cap is fully
located.
Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
TO REPLACE CuT LINE.
For your convenience it is recommended you
buy spool and line complete.
To fit spool and line complete:
Remove old spool.
Place new spool into cap with cut out areas
of the spool in line with eyelet.
15 15
EN