Worx WG151E Manual page 14

battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. HOw TO CHARgE yOuR bATTERy (See
Fig C&D)
Connect the battery charger to the power
supply and the green light (18) will illuminate.
Slide the battery pack into the charger to make
the connections. The green light (18) will be
off and the red light (19) will illuminate to
show charging has started. When charging is
completed the green light (18) will illuminate
while the red light (19) is off.
NOTE: This charger is designed to detect
some problems that can arise with battery
pack. (see table below)
Red flashing
Green Off
Red ON
14 14
Green Off
Green ON
Red Off
Green flashing
Red Off
4. TO REMOVE OR INSTALL bATTERy
PACK (See Fig E)
Depress the battery release button to
release battery pack from your trimmer.
After recharging, insert the battery pack into
trimmer's battery port. A simple push and
slight pressure will be sufficient.
5. SAFETy ON/OFF SwITCH (See Fig F)
Your switch is locked off to prevent accidental
starting. Depress lock off button (c) then on/off
switch (d) and release lock off button (c). Your
2-in-1 cordless Li-ion grass trimmer/edger
Defective battery, after
pre-charge 30 minutes
with trickle current, the
total battery voltage is
still less than 10.0V (When
charging 18V battery pack).
Charging
Power On and Fully
Charged
The temperature of
battery pack is less than
0 C or more than 45
O O
switch is now on. To switch off, just release the
on/off switch.
wARNINg! The cutting head
continues to rotate after the
trimmer has been switched off; wait until
it has completely stopped then lay down
the tool.
6. ADJuSTMENT OF THE TELESCOPIC
SHAFT (See Fig g)
Unscrew the lower locking knob (4) in the
direction indicated to unlock.
Adjust the length of the telescopic shaft to the
most comfortable length.
Tighten the lower locking knob.
7. MAIN HANDLE ROTATION (See Fig
H1, H2)
Holding the lower housing then pull upward
the shaft, then rotate 90 degree clockwise (See
Fig H1), then release, the shaft will be locked
in position automatically. (See Fig H2)
8. ADJuSTMENT OF AuxILIARy HANDLE
Pull up the auxiliary handle locking lever (5).
Hold the lever and rotate the auxiliary handle
to the most comfortable and balanced position
(See Fig I).
Release the lever, your auxiliary handle has
been locked.
9. ADJuSTMENT OF THE TRIMMER
HEAD ANgLE TO THE SHAFT
Adjust the trimmer head angle downwards,
Put your one foot on the motor house, then
grip the main handle, apply adequate force to
C
adjust, as shown in Fig J1.
Adjust the trimmer head angle upwards, Put
your one foot on the safety guard, then grip
the main handle, apply adequate force to
adjust, as shown in Fig. J2.
10. SPACER guARD
Push the spacer guard in and out into place
before trimming, as shown in Figure K. Make
sure the spacer guard is locked firmly.
EN