Operation; Setup; Cd-Tray; Lcd-Display - Omnitronic CDP-600 User Manual

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.

6.2 CD-tray

Press Open/Close-button in order to open the disc tray. The CD-tray opens and the display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray.

6.3 LCD-display

If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the total number of tracks and the total playback time are shortly displayed.
The player jumps to the first track and is in the Pause-mode (Play/Pause-LED flashes). Please note that the
player automatically jumps to the section where the music starts.
Above "TRACK" the track number is displayed. Above M (MIN), S (SEC) and F (FRAME) the track remain
time is displayed.
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed) or total remain time (Total Remain). For activating the Outro-function, press and
hold the Single-button. The display shows „Outro". In this mode, the last 30 seconds of every track are
played. Cancel the Outro-function by pressing the Time-button.
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 30 seconds before the track-end, the bars in the
display start flashing.
The indication "SINGLE" means that the CD-player is in Single-mode. The current track is then played once
and the player goes into Pause-mode at the beginning of the next track. By pressing the Single-button, the
CD-player changes into normal playback mode and the display shows "CONTINUE".
The indication "0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-button has to be pressed), the respective percentage is indicated in the display.

6.4 Play/Pause

In the Pause-mode the the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.
Press and hold the Time-button and the CD-player will be stopped.

6.5. Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
+10-button:
By pressing the +10-button, the CD-player jumps 10-stepwise from track number to track number (e. g. 06,
16, 26, 06).
26/55
10602320_V_1_0.DOC