Rear Panel; Installation; Operation; Setup - Omnitronic CDT-200 User Manual

4.3 Rear panel

14. AC CONNECTION
15. POWER SWITCH
Press this button to start operation.
16. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
17. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.

5. INSTALLATION

Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
17
17
14
15
16