Operation; Remote Control; Switching On/Off; Inserting A Cd - Omnitronic XCP-1400MT User Manual

6. OPERATION

The XCP-1400MT can either be operated via
the buttons on the front panel or via the remote
control.

Remote control

1
When actuating a button, always direct the
remote control towards the sensor. There
must be no obstacles between remote
control and the sensor.
2
If the range of the remote control decreases,
the batteries are probably exhausted and
must be replaced.

Switching on/off

Switch on the XCP-1400MT with the
1
power button.
• The unit will automatically detect if a CD is
inserted (indication "LOAD CD").
• If a CD is inserted, the display will shortly
indicate the total number of titles and the
total remain time followed by information
concerning the first title after the read-in.
• If no CD is inserted "NODisc" will be
displayed.
2
Prior to switching the unit off, always
terminate the playback with the button [►II]
or the button []. Then press the power
button to switch off the unit.

Inserting a CD

1
To insert a CD, open the CD tray with the
button [ ].
• The control LED lights.
• The display will show "OPEN".
2
Insert the CD with the lettering facing
upwards and close the CD tray again with
the button [ ].
• The display will show "CLOSE".
• The control LED flashes during the read-in
Selecting titles
1
For selecting titles use the buttons [

[ ] which allow to skip one title or several
titles in forward or backward direction.
• Each time the button [] is pressed, the unit
will advance one title.
• By pressing the button [], the unit will go to
the beginning of the title and with each
further actuation, the unit will go back
another title.
2
By pressing the button [+10], the unit will
advance 10 titles.
3
For direct selection of a title with the
numerical keys [0-9] on the remote control,
enter its number.
• When entering a one-digit number, press [0]
first.
• Examples: For title number 1 press key [0]
and [1]. For title number 27 press key [2] and
[7].

Starting playback/pause

Press the button [►II], to start playback.
1
• The display indicates ►.
• During playback, the red LED lights.
• The
starting
automatically be stored in the memory as the
cue point. The unit will return to this cue
point by shortly pressing the button CUE.
2
Playback can be interrupted at any time with
the button [►II].
• The display indicates II and the red LED
starts flashing.
• To continue, press the button [►II] once
again.
• Pressing the button CUE during playback
also interrupts the playing and returns the
title to the cue point.
30/36

] and
point of the title
00075262.DOC, Version 1.0
will