Installation; Operation; Setup; Cd-Tray - Omnitronic CDP-430 User Manual

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Rack-installation: This CD-player is built for 19" racks (482 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.

6.2 CD-tray

Press Open/Close-button in order to open the disc tray. The CD-tray opens and the display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray.

6.3 LCD-display

If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the total number of tracks and the total playback time are shortly displayed.
The player jumps to the first track and is in the Pause-mode (Play/Pause-LED flashes). Please note that the
player automatically jumps to the section where the music starts.
Above "TRACK" the track number is displayed. Above M (MIN), S (SEC) and F (FRAME) the track remain
time is displayed.
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed).
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 15 seconds before the track-end, the bars in the
display start flashing.
The indication "CONTINU" means that the CD-player is in normal playback mode. By pressing the Single-
button, the CD-player is put into Single-mode and the display shows "SINGLE".
20/44 10602259_V_2_0.DOC