Philips RQ1200 series Instruction Manual page 34

English
34
Problem
The shaver does
not work when I
press the on/off
button.
Possible cause
Specific types only: The
Jet Clean System has not
cleaned the shaver properly,
because the cleaning fluid
in the cleaning chamber is
soiled or the cleaning fluid
level is too low.
The rechargeable battery is
empty.
Specific types only: The
travel lock is activated.
The shaving unit is soiled or
damaged to such an extent
that the motor cannot run.
In this case, the shaving unit
symbol, the tap symbol and
the exclamation mark flash.
The temperature of the
shaver is too high. In this
case, the shaver does not
work and the exclamation
mark on the display flashes.
Solution
Clean the shaver
thoroughly before
you continue shaving.
If necessary, clean
and refill the cleaning
chamber (see
chapter 'Cleaning and
maintenance').
Recharge the
battery (see chapter
'Charging').
Press the on/off
button for 3 seconds
to deactivate the
travel lock.
Clean the shaving
unit or replace it (see
chapters 'Cleaning
and maintenance'
and 'Replacement').
Switch off the shaver
and let it cool down.
As soon as the
temperature of the
shaver has dropped
sufficiently, you can
switch on the shaver
again.