Philips RQ1200 series Instruction Manual page 24

English
24
, The cleaning chamber remains behind.
4 Unscrew the cap from the bottle with HQ200
cleaning fluid.
5 Fill the cleaning chamber with HQ200 cleaning
fluid to a level between the two lines.
6 Place the Jet Clean System back onto the
cleaning chamber.
Make sure the release buttons click back into place.
Using the Jet Clean system
Note: If you use the shaver with shaving foam or
shaving gel, we advise you to rinse it under the hot
tap before you clean it in the Jet Clean System. This
guarantees an optimal lifetime for the cleaning fluid.
1 Hold the shaver upside down above the holder
with the back of the shaver pointing towards
the holder.
2 Place the shaver body in the holder behind the
two clips (1) and press it down until it locks
into place (2).
, The display shows that the shaver is charging
(see chapter 'The display').
3 RQ1008: Press the up/down button to select a
cleaning program.
4 Press the on/off button on the Jet Clean
System to start the cleaning program.
, The shaver display stops showing the charging
indication.
, The cleaning light starts to flash and the shaver is
automatically lowered into the cleaning fluid.
, The cleaning light flashes throughout the
cleaning program, which takes a few minutes.