Step 2: Connect To Electricity Supply; Step 3: Check Edging Strip - Belling BI 60 I Users Manual And Installation Handbook

Step 2: Connect to the electricity
supply
We recommend that the appliance is
connected by a competant person,
who is a member of a competant per-
son scheme and who will comply with
the I.E.E. and local regulations.
Important: Ensure that you route all
mains electrical cables well clear of
any adjacent heat source, such as an
oven or grill.
Warning: This appliance must be
earthed.
1. A fixed connection is used, a
device allowing the appliance to
be isolated on all poles from the
mains supply with a contact
opening width of at least 3mm
must be provided.
Use a 13 amp fuse.
2. It is recommended that type HO5
V V-F cable must be used as the
mains lead.
3. The mains terminal block is
positioned at the right hand rear of
the top service panel.
5. Connect the cable to the terminal
block, and tighten the cable clamp.
6. Close the terminal box, ensuring
that the cover is engaged on the
locking tabs.
Installation Instructions

Step 3: Check edging strip

The edging strip is factory fitted to
the front side edges of the appliance
front frame.
cabinetry with extra protection from
any escape of heat.
When installing the product, ensure
that the edging strip is correctly located
on the outer edges of the front frame,
before positioning and securing the
appliance to the cabinet.
When securing the appliance, the
fixing screws provided are driven
through the edging strips into the
cabinet - the seal will straighten up
and sit flush to the cabinet when the
screws are fully home.
31
This strip provides the
Front frame
Handle
Door