Table of Contents
Advertisement
Drain Hose Installation
Care must be taken when installing the drain hose for the indoor unit to ensure that any condensation water is
correctly drained outside. When passing the drain hose through the 65 mm hole drilled in the wall, check that none
of the following situations occur.
The hose must NOT
slope upwards.
Shield
Drain hose
Extension drain hose
20
E-
The end of the drain
Do NOT bend the
hose must NOT be
hose in different
placed in water.
directions.
To install the drain hose, proceed as follows.
1
If necessary, connect the 2m extension to the drain hose.
2
If you are using the extension, insulate the inside part of the extension drain
hose with a shield.
3
Pass the drain hose under the refrigerant piping, taking care to keep the drain
hose tight.
4
Pass the drain hose through the hole in the wall, making sure that it is sloping
downwards, as shown in the illustrations above.
5cm
less
Keep a clearance of at
Do NOT place the end
least 5-cm between
of the drain hose in a
the end of the hose
hollow.
and the ground.
Ditch
Advertisement
Table of Contents
