Connect Your Fbus-Hse/H1 Ld To The Network - National Instruments Fieldbus User Manual

Chapter 2 Hardware Installation and Configuration

Connect Your FBUS-HSE/H1 LD to the Network

Note Do not use a cable longer than 100 m. If you are using a 10 Mbps Ethernet, National
Instruments recommends using a Category 5 shielded twisted-pair Ethernet cable.
FBUS-HSE/H1 LD User Manual
Connect the RJ-45 Ethernet port of the FBUS-HSE/H1 LD to an Ethernet
hub using a standard Category 5 Ethernet cable. You also can connect an
FBUS-HSE/H1 LD directly to a computer using an Ethernet crossover
cable.
Figure 2-4 shows the power, H1, and Ethernet connectors on the
FBUS-HSE/H1 LD.
1
1 H1 Port 1 2 H1 Port 2
Figure 2-4. Connectors on the FBUS-HSE/H1 LD
3 Power
2-4
2 3
4 Ethernet
4
ni.com