Changing Grinding Tools - HTC GL 270 User Manual

HTC GL
270/400/450/550
4.4.2

Changing grinding tools

1. Remove the grinding tool by giving it a few light taps with a rubber hammer so
the locking mechanism releases,
up out of the guide slot.
Figure 4-4. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide
slot on the tool holder,
the guide slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a
rubber hammer - see
4.5 Preparations for dry grinding
Note!
Make sure that the floating cover can move freely within its movement margins
and that the cover rests on the floor before starting the machine.
1. Connect a dust extractor to the machine. For dust extractor models, see under the
Suction System tab in the HTC Product Catalogue.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
1.0
see Figure 4-2, page
Figure 4-3, page
Note!
The dust extractor's suction hose must be connected to the appropriate
socket on the machine. Adjust the dust extractor to match the grinder's
capacity.
see Figure 4-4, page 17. Then draw the tool
16. Then push the tool fully into
16.
Usage
17