HTC GL 270 User Manual page 20

Safety
Note!
The machine may only be lifted using the lifting eye on the chassis in
accordance with the relevant instructions.
Note!
Make sure that the floating cover can move freely within its movement margins
and that the cover rests on the floor before starting the machine.
Note!
The machine should be stored in a dry, warm (plus degrees) location when not
in use.
Note!
If the machine is stored in a cold (minus degrees) location, it must be placed in
a warm (plus degrees) location for at least two hours before use.
Note!
The appropriated dust extractor must be used when dry grinding. Contact HTC
for model recommendation.
Note!
The dust extractor's suction hose must be connected to the appropriate socket
on the machine. Adjust the dust extractor to match the grinder's capacity.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies.
Note!
As long as the emergency stop switch is pressed in, the machine cannot be
started. Reset by turning the switch 45° clockwise so that it pops out again. The
machine can then be restarted.
Note!
Check that all the parts are correctly attached and that all the screws are
tightened properly before the machine is started.
Note!
After removing glue, always lift the grinding heads so they do not stick to the
floor and damage machine components or the floor when the machine is
restarted.
8
HTC GL
270/400/450/550
1.0