Repairs; Every Month (Or 100 Hours); Spare Parts - HTC GL 270 User Manual

HTC GL
270/400/450/550
5.5

Every month (or 100 hours)

• Check that all screws and joints are tightened and correctly attached.
• Check that the grinding cover is whole and undamaged.
• Check the upper belt and replace if necessary. See under
unevenly (only applies to HTC GL 450 and HTC GL 550), page 29
instructions on how to perform the check.
• Check the seals on the shafts on which the upper belt runs and replace if
necessary, (only applies to HTC GL 450 and HTC GL 550).
• Scrape and vacuum-clean the parts shielded by the grinding cover.
• Test run and listen for any dissonance from the bearings.
5.6

Repairs

Any repairs that may be required must be carried out by a HTC Service Centre, which
has trained service personnel and uses HTC original parts and accessories. Contact your
retailer if your machine requires servicing. For contact information, see Contact
Information at the start of the manual.
5.7

Spare parts

To ensure rapid delivery of spare parts, always specify the model, the machine's serial
number and the spare part number when ordering. Information on the model and serial
number can be found on the machine's name plate.
Information on spare part numbers can be found in the machine's spare parts list which
is available to read or print out from the accompanying digital media or HTC's website:
www.htc-floorsystems.com
Only original tools and original spare parts from HTC may be used. Otherwise neither
the CE marking nor the warranty will be valid.
1.0
Maintenance and repairs
The machine grinds
for
27