Starting And Stopping The Machine - HTC GL 270 User Manual

Usage
4.7.1

Starting and stopping the machine

1. Connect the electricity supply by plugging in the plug.
2. Make sure the emergency stop switch is reset.
3. Turn the Power knob to "I" to start the machine. Hold the knob in the start
position "I" for ca 1-2 seconds.
4. Turn the Power knob to "O" to switch off the machine.
4.7.2 Emergency stop switch
The emergency stop switch must only be used in an emergency.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies.
Note!
As long as the emergency stop switch is pressed in, the machine cannot be
started. Reset by turning the switch 45° clockwise so that it pops out again. The
machine can then be restarted.
Note!
Do not hold the knob in start position "I" longer than is needed to start the
machine. Holding the knob in start position "I" for longer will damage the
machine.
4.8 Making operation easier
In order to keep the suction hose for the dust extractor and the power cable out of the
working area and/or path of the machine, the hose and cable can be arranged as shown
in the picture below.
20
HTC GL
270/400/450/550
1.0