Table of Contents
Advertisement
HTC GL
270/400/450/550
3
Machine description
3.1
General machine description
The machine is constructed from a number of main components, see
10
and
Figure 3-2, page
number of different motor alternatives, see tables in
The machine is based on a wheeled chassis. The motor with the rotating grinding unit is
mounted on the lower part of the chassis enabling some movement between the chassis
and the motor assembly.
The machines in the series are equipped with a lifting eye on the chassis and two lifting
handles on the grinding head, see
for lifting the complete machine. The lifting handles are intended for lifting the grinding
head, when it is separated from the chassis, and then only for short, low lifts, e.g. into
the boot of a car. The lifting handles are not to be used for lifting the complete machine.
The handle can be placed in a number of different working positions by loosening the
locking mechanism for adjusting the handle (see
the handle up and down to the desired working height. The angle of the handle (see
Figure 3-2, page
can also be placed in the upright position, which must be used when the machine is
tipped to enable access under the grinding head, e.g. when changing tools.
The machine has a connection for an external suction hose, which is used during dry
grinding.
The machine can be easily equipped with a large number of tools, depending on the
material to be ground. For the different tools, see HTC's Product Catalogue under the
Grinding Guide tab.
1.0
11. For each machine model in the series, there are a
Figure 3-1, page
11) can also be adjusted to obtain the best ergonomics. The handle
Machine description
Figure 3-1, page
Technical data, page
10. The lifting eye is intended
Figure 3-2, page
11) and moving
30.
9
Hide quick links:
Advertisement
Table of Contents
