Conference Calls - Panasonic ICX Section 700 Technical Manual

Section 700 - Operation
To answer a Camp-on (Call Waiting) signal:
1. Replace the handset.
2. Lift the handset again to be connected to the waiting call.
OR....
Hookflash.
Hardware Requirements
• N/A
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See "To camp a call onto a
busy extension:" on page 266.

Conference Calls

CPC-96, CPC-288, and CPC-576 Version 3.0
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
The CPC Version 3.0 software release allows any combination of extensions and trunk lines be in the
conference as long as the original extension is in the conference and the total number of parties does
not exceed 8. With CPC Version 3.0 software, only one operation is used to establish and add to a
conference. You simply have to place the current call on hold, dial the next party and press the CONF
key. No different operation or access code is required to add additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party

conference calls:

• 3 extensions
• 2 extensions and 1trunk
• 1 extension and 2 trunks
Operation
To establish a conference call:
1. While on a call, hookflash to place your current call on hold.
2. If adding an outside party, dial a trunk access code (default
= 9 [UK/HK], 0 [Taiwan, Malaysia, Indonesia], or 81-84).
ICX-35-700
Action
Action
ICX (International), issued March/1999
Chapter 7. SLT Features
Result
• Current call placed on hold
• Connected to waiting call
Result
• Outside dial tone
279