Panasonic ICX Section 700 Technical Manual page 244

Chapter 6. DSLT Features
To delete a PSD number:
1. Lift the handset or press the ON/OFF key.
2. Enter the Speed Dial Set/Clear code (default = 710 [UK/
HK] or 710# [Taiwan, Malaysia, Indonesia]).
3. Enter the PSD bin number (80-99).
4. Press the HOLD key.
5. Replace the handset or press the ON/OFF key.
Hardware Requirements
• N/A
Considerations
• Storing a new number erases any previously stored data.
• Speed Dial numbers can contain up to 24 characters. The following table reflects which keys to
use.
To indicate . . .
Digit or character
Intercom Level *
MCO Code 9 (UK/HK) or 0 (Tai-
wan, Malaysia, Indonesia)**
MCO Code 81**
MCO Code 82**
MCO Code 83**
MCO Code 84**
Pause
DP - DTMF Code
SSD Code
Hyphen (-)
DTMF Conversion After the
Other Party Answers
* Indicates that the digits that follow are either a feature access code or an extension
number. (Not needed if your System is set for Intercom Level.) See Note below.
** Indicates that the digits that follow are for an outside number and the System should
seize the next available trunk when dialling. (Not needed if your System is set for Trunk
Level.) See Note below.
Note: The System has two levels - Trunk Level and Intercom Level. If set at Trunk Level
(default), you must enter the code for Intercom Level when programming a feature access code
244
Action
Enter/Press
0, 1 - 9, *, #
MEMORY * #
MEMORY * 0
MEMORY * 71
MEMORY * 72
MEMORY * 73
MEMORY * 74
REDIAL
MEMORY * *
MEMORY NN(N)
PROG
MEMORY * 3
(Version 3.5 or
higher)
ICX (International), issued March/1999
Section 700 - Operation
Result
Intercom dial tone
ICX-35-700