Yowza Daytona Plus User Manual page 36

YOWZA DAYTONA TREADMILL 36
COMPUTER OPERATION
HOW TO USE THE CHEST BELT PROPERLY
For proper operation, the chest belt should be worn with the monitor strapped across the front of your body just above the chest line as
shown in the drawing on the right. The monitor needs a little body heat and moisture in order to work properly. To ensure correct
operation you may want to wet the two rubber pickups under the belt prior to exercising.
ENGLISH/METRIC CONVERSION – (KM / ML.)
Power on the treadmill, press and hold the START button then turn up the safety key to power on the computer. The console will enter
into the UNIT CONVERSION MODE. The console will sound a BEEP and show the current default setting KM (kilometers) or ML
(miles). Use START to switch between KM and ML. Press STOP to confirm the selection and return to POWER ON MODE. The
console will sound an extended BEEP as it saves the new setting.
SLEEP MODE
When the power is on the computer will automatically enter SLEEP MODE if there is no movement for 3 minutes without receiving any
input. Press any button to return to POWER ON MODE when the computer is in the SLEEP MODE.
QUICK START MODE
Press the START after power on the treadmill to enter Quick Start workout mode, when in QUICK START MODE, the treadmill will
countdown from 3 to zero and then the belt start at 0.8km/h or 0.5 mph speed. The workout Time, Distance and approximate Calories
figure will count up from 0. The running speed will also display on screen. The user can press SPEED-UP and SPEED-DOWN button
to adjust running speed, and press INCLINE-UP and INCLINE-DOWN buttons to adjust the INCLINE level.
Press the STOP button to pause the program, and START to restart, or press STOP again to return to POWER ON MODE.
COOL DOWN
After completion of each program the TIME LCD window will show "COOL" and blink then start a 50 seconds cool down procedure.
Time counts down from 01:00 to 00:00 and speed stays at 2 mph / 3.2 km/h and the incline level stays at level 0. Press the STOP
button to return to POWER ON status. To escape the cool down procedure press the STOP button once anytime during the process to
enter the PAUSE status and press the STOP button again to enter the POWER ON status.