Monte Carlo Fan Company 3ADR60 Series Owner's Manual And Installation Manual

Monte Carlo Fan Company 3ADR60 Series Owner's Manual And Installation Manual

Hide thumbs Also See for 3ADR60 Series:

Advertisement

Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3ADR60XXX Series Fan
CUL Model NO. : 3ADR60
RETAILER NAME:
RETAILER ADDRESS:
5.1 kgs
11.22 lbs
Total fan weight

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3ADR60 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Monte Carlo Fan Company 3ADR60 Series

  • Page 1 Owner’s Guide and Installation Manual 3ADR60XXX Series Fan CUL Model NO. : 3ADR60 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 5.1 kgs 11.22 lbs Total fan weight...
  • Page 2: Cautions And Warnings

    Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2017 Monte Carlo Fan Company 09/2018...
  • Page 3: Safety Cable Installation

    Note: Make sure the side with a label washers and lock washers provided. “This side up” is installed upward. Note : If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The Outlet Box. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 4 Carefully insert a phillips screwdriver through yoke and downrod (don’t damage the lead wires) as a guide and then push the cross pin and pull the screwdriver in the meantime as shown in illustration. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 5 The splices after being made should be turned upward and pushed carefully up into the outlet box. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 6 Reinstall the screw tight. removed in step 17 and tighten all screws securely. Do not over tighten it. © 2017 Monte Carlo Fan Company 09/2018...
  • Page 7: Remote Control Setting And Operation

    Setting for both transmitters must be seconds done within 1 minute of restoring power to the fan. A fan can be controlled by 2 transmitters maximum when choose Learning Mode. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 8 5. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 9: Troubleshooting

    5.Remove light kit and check the plug connections if they are present. 6.If this fan uses remote controller, make sure dip switches are setting properly and make CAUTION: Make sure main power is turned off before entering switch housing and/or canopy. © 2018 Monte Carlo Fan Company 09/2018...
  • Page 10 Nov.2018...

This manual is also suitable for:

3adr60

Table of Contents