Download Print this page
Monte Carlo Fan Company 3AMR60 D Series Owner's Manual And Installation Manual

Monte Carlo Fan Company 3AMR60 D Series Owner's Manual And Installation Manual

Advertisement

Quick Links

Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3AMR60XXXD Series Fan
cETL Model NO. : 3AMR60(X)
RETAILER NAME:
RETAILER ADDRESS:
6.6 kgs
14.52 lbs
Total fan weight with light

Advertisement

loading
Need help?

Need help?

Do you have a question about the 3AMR60 D Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Monte Carlo Fan Company 3AMR60 D Series

  • Page 1 Owner’s Guide and Installation Manual 3AMR60XXXD Series Fan cETL Model NO. : 3AMR60(X) Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.6 kgs 14.52 lbs Total fan weight with light...
  • Page 2: Cautions And Warnings

    Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2018 Monte Carlo Fan Company 10/2018...
  • Page 3 Remove the top housing. Insert blades (the 3 blades with a label screws. “This side up”) into the top slots on flywheel. Note: Make sure the side with a label “This side up” is installed upward. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 4 Note: Make sure to tighten the set screws of top blades with the bracket. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 5 20º. Note : If Installing The Secondary Support result in serious injury. Safety Cable in the U.S., Do Not Remove Knockouts In The Outlet Box. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 6 Reinstall the screw removed in step 20 clockwise till lock. and tighten all screws securely. Attach canopy bottom cap onto canopy by aligning its notch with the screws on mounting bracket and twist clockwise till tight. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 7 Reinstall the twist clockwise until tight. plate and twist clockwise until tight. screws removed in step 25. Tighten all Note: Do not install LED light kit if screws securely. use blanking plate. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 8: Transmitter Operation

    Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 9 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 10: Troubleshooting

    5.Remove light kit and check the plug connections if they are present. 6.If this fan uses remote controller, make sure dip switches are setting properly and make CAUTION: Make sure main power is turned off before entering switch housing and/or canopy. © 2018 Monte Carlo Fan Company 10/2018...
  • Page 11 Oct.2018...

This manual is also suitable for:

3amr60