Automatic Needle Threader; Pulling Up The Bobbin Thread - JUKI HZL-G220 Instruction Manual

Automatic needle threader

1
Threading lever
A
Lower the presser foot.
Raise the needle. Then, lower the needle threader
halfway (until it becomes heavy) and thread the
thread to A .
2
Lower the needle threader fully. Then, thread the
thread between the guides completely. (Needle
threader will catch the thread through needle
eye.)
3
Release the threading lever and the needle thread
is threaded to the needle eye.
4
Pull the thread backward.
Pull out the thread from the needle eye by approx. 10 cm
or 4 inches long.

Pulling up the bobbin thread

Basic operation:
You can start to sew without pulling up the bobbin thread,
however, if you want to sew with the bobbin thread pulled
out, follow the directions below.
1
Lift the presser foot and lightly hold the end of
the needle thread.
2
Turn the hand wheel towards you to move the
needle up and down. Loop of bobbin thread will
be pulled out when you will pull the needle thread
lightly.
3
Pull out both needle and bobbin threads by
approx. 10 cm (4 inches) long and pass them
under the presser foot towards the back of the
machine.
17