Buttonhole Stitches - JUKI HZL-G220 Instruction Manual

Buttonhole stitches

Attention
* The buttonhole length is automatically determined only by placing a button on the buttonhole presser foot.
* The machine can sew buttonholes for buttons with diameters of 0.7 - 2.6 cm.
* In case of stretchy fabrics, use non-elastic interlining on the wrong side of the fabric.
* Make sure to perform test sewing to see that the machine sews buttonholes correctly.
* Practical pattern No. 26, 27 are for knit fabrics and should be used with a knit needle.
Buttonhole type
Standard
09
buttonhole
23
Rounded
end
25
24
Keyhole
1
2
Button holder
A
B
30
Pattern No.
Presser foot
Turn OFF the power switch before replacing the presser foot.
Buttonhole for medium to heavy
weight materials
Standard buttonhole
Buttonholes for women's
blouses and children's clothes.
Also for light weight materials
Keyhole buttonhole for heavy
weight materials such as suits,
jackets, coats, etc.
Groove
Pin
Practical 09, 23~29
Buttonhole presser foot (E)
26
27
28
Decorative
29
Set the presser foot.
Push the needle up/down button to raise the needle and lift the presser
foot.
Align the groove of the presser foot holder with the pin of the presser
foot and lower the presser foot holder to set.
Set the button.
Pull the button holder toward A , place the button on the button holder,
and then push the holder toward B to set the buttonhole length.
* It is impossible to set a button thicker than 4mm.
Buttonhole for light weight knit
(also used as decorative
buttonhole)
For knit
Buttonhole for medium weight
knit (also used as decorative
buttonhole)
Decorative buttonholes
Decorative buttonhole which
look like hand-sewn