Can-Am ds 450 series Operator's Manual page 114

MAINTENANCE PROCEDURES
NOTE: X xc and X mx models are
equipped with tapered nuts and do
not have washers.
NOTICE
To avoid any damage to
front brake discs, never remove or
ride vehicle without front discs pro-
tectors properly installed.
vmo2008-011-103
DISC PROTECTOR
Wheel Installation
At front, ensure that brake discs pro-
tectors are properly installed.
vmo2008-011-104_a
FRONT WHEEL
1. Disc protector
Install nuts.
WARNING
On X xc and X mx models, install
the tapered side on the nuts to-
wards rim.
______________
112
Gently tighten nuts in a criss-cross
sequence then apply a final torque of
52 N•m (38 lbf•ft).
NOTICE
Always use the recom-
mended wheel nuts and washers (if
applicable). Using a different nut
and washer could cause damages to
the rim.
Tire Replacement
(Wheels Without Beadlocks)
Use an automotive tire changer to re-
place tires.
Adjust tire pressure. Refer to
PRESSURE
in this section.
WARNING
– Replace tires only with the same
size as original tires.
Tire Removal (Beadlock Wheels)
1. Remove wheel from the vehicle.
2. Completely deflate tire.
3. Loosen all beadlock bolts a few
turns at a time in a criss-cross pat-
tern.
4. Remove beadlock bolts.
5. Remove beadlock clamp ring.
vmo2012-016-004_b
1. Beadlock bolts
2. Beadlock clamp ring
6. Remove tire from the beadlock side.
TIRE