Table of Contents
Advertisement
Align the bottom key holes on right side shelf
loosened screws, and tighten these two screws as shown
in Fig. 11.
.
Use
three
1/4-in. x 15-mm truss head screws
washer
(AA)
and three 1/4-in. Flat Washer(DD),
the right side shelf(O) in place.
Note: Screw the three 1/4-in. x 15-mm truss head
screws with locking washer (AA) to align the right side
shelf from inside to outside. Screw the two screws on the
right panel of firebox from outside to inside.
9. Left Side Shelf Assembly
Repeat step 8 for the left side shelf.
10. Push Bar Assembly
Take out the push bar
flange of left side shelf with two1/4-in. x 12-mm screw
with locking washers (BB)
Note: These two screws are tighten from under the
left side shelf.
(M)
from carton, align it to the left
as shown in
Fig. 13.
(O)
with two
with locking
to keep
AA
1/4-in. x 15-mm truss head screw with locking
washer (AA) 3 x
1/4-in. Flat Washer(DD) 3 x
10
Fig. 11
Fig. 12
DD
Fig. 13
BB
M
1/4-in. x 12-mm truss head screw with
locking washers (BB) 2 x
O
O
Advertisement
Table of Contents
