Sony MXD-D3 Service Manual page 28

MEANINGS OF OTHER DISPLAYS
Display
H During continuous playback (CLV: ON)
X Tracking servo OFF
REC Recording mode ON
SYNC CLV low speed mode
L.SYNC ABCD adjustment completed
OVER Tracking offset cancel ON
REP Tracking auto gain OK
1 Focus auto gain OK
TRACK (under) Pit
DISC (under) High reflection
SHUF CLV-S
MONO CLV LOCK
TOC EDIT Jitter monitor
CD SECTION
Set the CD test mode when performing confirmations.
After completing confirmation, release the CD test mode.
1. AGING MODE
This mode repeatedly opens and closes the CD tray, and plays CD.
This operation is repeated unless an error occurs. If an error occurred, the aging stops.
Procedure:
(1) Set a disc in advance.
(2) Enter the test mode, then rotate
(3) When "AGING **" is displayed on the FL tube, rotate
[ AMS
(4) Press the
l L
Aging sequence
00: Normal
01: Normal + Exchange (not used)
02: Never mind
03: Never mind
04: BD access
05: Sound skip
06: Reverse to normal
(5) To finish the aging, press the
2. COMMAND TRANSFER MENU
Procedure:
(1) Enter the test mode, then rotate
knob.
(2) Select a command with
(3) Select the edit position with
[ AMS ]
(CD) knob for transfer.
l L
(4) To exit from this mode, press
3. C1, C2 ERROR DISPLAY
Procedure:
(1) Enter the test mode, then rotate
(2) C1 error and C2 error are displayed on the left side and right side with 4-digit codes respectively.
(3) To exit from this mode, press
4. DISC SPEED SELECTION
Procedure:
(1) Enter the test mode, then rotate
[ AMS
(2) Each time the
l
(3) To exit from this mode, press
28
Contents
When Lit
[ AMS ]
(CD) knob to display "0> AGING", and press the
l L
]
(CD), and the aging is executed through the following sequence.
x (CD) button.
[ AMS ]
l L (CD) knob to display "1> COMMAND", and press the
[ AMS ]
l L
(CD) knob, and press the
(CD) and (CD) buttons, and rotate
m M
[
x (MD) button and l
[ AMS ]
(CD) knob to display "2> ERROR", and press the
l L
[
x (MD) button and l
[ AMS ]
(CD) knob to display "3> SPEEDx1", and press the
l L
]
(CD) knob is pressed, the speed changes over such as x1 t x2 t x4 t x1.
L
[
(MD) button and l
x
When Off
STOP (CLV: OFF)
Tracking servo ON
Recording mode OFF
CLV normal mode
Tracking offset cancel OFF
Groove
Low reflection
CLV-A
CLV UNLOCK
[ AMS ]
(CD) knob so that ** portion becomes 00.
l L
[ AMS
l L
[ AMS
l
AMS ]
L (MD) knob simultaneously.
AMS ]
L (MD) knob simultaneously.
AMS ]
L (MD) knob simultaneously.
[ AMS
l L
[ AMS
l
]
(CD) knob to set.
]
L (CD) knob for editing, then press the
[ AMS
l L
[ AMS
l L
]
(CD).
]
L (CD)
]
(CD) knob.
]
(CD) knob.