Sony MXD-D3 Service Manual page 20

CD BASE UNIT (BU-5TBD26B)
1 two screws
3 two compression springs (932)
BD (CD) BOARD
Note: When routing the lead wires of spindle motor,
pass them through a slot in the BD (CD) board,
then solder to the motor. Then, secure the lead wires
to the IC191 with an adhesive sheet so as not to be loose,
as shown in the figure.
IC191
spindle motor
20
(PTPWHM2.6)
adhesive sheet
motor leads
2 Remove two solders
of spindle motor leads.
1 two screws
(PTPWHM2.6)
2 CD base unit (BU-5TBD26B)
3 two compression springs (932)
4 chassis (MD)
3 two screws
(P2 × 3)
1 wire (flat type) (16 core)
(CN102)
5 BD (CD) board
4 screw
(BVTP2.6 × 8)