Sony MXD-D3 Service Manual page 26

5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
(1) Set the disc in the unit. (Whichever recordable discs or discs for playback only are available)
[ AMS
(2) Turn the l L
[YES]
(3) Press the button to change the display to "CPLAY MID".
(4) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
[YES]
(1) Press the button during continuous playback to change the display as below.
"CPLAY MID" t "CPLAY OUT" t "CPLAY IN"
When pressed another time, the parts to be played back can be moved.
(2) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
[MENU/NO]
(1) Press the button. The display will change to "CPLAY MODE".
[ EJECT]
(2) Press the button and take out the disc.
A
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check)
1. Entering the continuous recording mode
(1) Set a recordable disc in the unit.
[ AMS
(2) Turn the
l L
[YES]
(3) Press the button to change the display to "CREC MID" (C31).
(4) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
[YES]
(1) When the button is pressed during continuous recording, the display changes as below.
"CREC MID" t "CREC OUT" t "CREC IN"
When pressed another time, the parts to be recorded can be changed. "
(2) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
[MENU/NO]
(1) Press the button. The display changes to "CREC MODE" and "
[ EJECT]
(2) Press the A button and take out the disc.
Note 1: The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
[MENU/NO]
Note 2: The
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If the unit entered this mode accidentally, press the
26
]
(MD) knob and display "CPLAY MODE" (C30).
]
(MD) knob and display "CREC MODE".
button can be used to stop recording anytime.
AD = ".
AD = ".
REC
" and " " lights up.
REC
" goes off.
REC
" and " " lights up.
REC " goes off.
[MENU/NO]
button immediately to release it.