Decal needs to be placed on or near battery box for future service
reference. One 5/16 in. and one 3/8 in. hex nut are supplied per
battery for wing nut replacement. Metric hex nuts are not supplied.
Propeller Replacement
Rotating propellers can cause serious injury or death. Never
operate the boat out of the water with a propeller installed. Before
installing or removing a propeller, place the drive unit in neutral
and engage the lanyard stop switch to prevent the engine from
starting.
1. Shift outboard to neutral (N) position.
IMPORTANT: Refer to Spark Plug Inspection and Replacement
for removing spark plug leads.
MAINTENANCE
NOTICE - DTS & Optimax Engines
DO NOT USE DEEP CYCLE BATTERIES!
DTS (Digital Throttle and Shift) applications and
Optimax engines must use a marine starting
battery with 1000 MCA, 800 CCA, or 180 Ah.
rating.
IMPORTANT:
Battery cable size and length is critical. Refer to
engine installation manual for size requirements.
Place decal on or near battery box for future service
reference. 5/16" and 3/8" hex nuts supplied for
wing nut replacement. Metric hex nuts not supplied.
WARNING
!
13.5Nm (120 lbs. in.)
DO NOT
USE WING
NUTS.
37-895387
N
26838
64
3486