I X . C A R E A N D M A I N T E N A N C E
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power lead, for wear or damage.
Have your authorised Pride Dealer repair or replace any damaged connector, connection or insulation
that you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections away from sources of
dampness, including direct exposure to water or bodily fluids and incontinence. Check
electrical components frequently for signs of corrosion and replace as necessary.
ABS PLASTIC SHROUDS
The front tiller shroud, front shroud and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
LIGHT BULB REPLACEMENT
The scooter's light bulbs are easily replacable. Do not use regular automotive-type 12-volt light bulbs;
your scooter is equipped with a 24-volt electrical system. Replacement light bulbs can be purchased from
your authorised Pride Dealer.
NOTE: Use only 24-volt light bulbs.
1. Remove the light cover.
2. Gently remove the bulb by pulling it straight out.
3. Insert a new bulb of the same wattage.
4. Replace the light cover.
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 28 and 29.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being
replaced. Failure to use properly rated fuses may cause damage to the electrical system.
Figure 28. Working Fuse
Figure 29. Blown Fuse (Replace)