Cold Water Connection; Positioning The Appliance; Water Outlet - Omega PL403A Instruction Manual

Positioning the Appliance

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate pro per installation.
How to Drain Excess Water From Hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will b e necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.

Water Outlet

Connect the water d rain hose. The drain hose must be correc tly fitted to av oid wate r leaks.
En sure that the water inlet hose is not kinked or s quashed.
Extension Hose
If you n eed a drain hose extension, make sure to use a similar dra in hose.
It must be no longer than 4 metres; o therwise the cleanin g effect o f the dishwasher could be re duced.
Syphon Connection
Insert the drain hose into a d rain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avo id bending o r crimping it. The top of the hose mus t be less than 100 0mm.
The following things should be checked before starting the dishwasher.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
please close the hydrant after using.