Change The Programme; At The End Of The Wash Cycle; Unloading The Dishwasher - Omega PL403A Instruction Manual

When you press the Start/Pause button to pause during washing, the
stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.
Premise:
1 A cycle that is underway can on ly be modified if it has only been running for a short time. Otherwise, the
detergent may have already be en released, a nd the appliance may have already drained the wash water.
If this is the case , the detergent dispenser mu st be refilled (see the section entitled " Loading the
Detergent " ).
2 Press the On/Off button to stop washing ,
the des ired cycle setting (see the section entitled " Sta rting a wash cycle. . ." ).
If you open the door
stop blinking and the buzzer will sound every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
A forgotten dish can be added any time before the detergent cup opens.
1 Press the Start/Pause Button to stop the washing.
2
Open the door a little .
3 After the spray arms stop working, you can open the door
completely.
When the wo rking cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supp ly and open the door of the dishwasher.
Wait for a few minutes before unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while they
are still hot and more susceptible to break age. The y will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.

Unloading the dishwasher

It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Wash th e arms in soapy and warm water and use a soft brush to
When following this procedure from step1 to step 3, the filter system will be removed;
clean the jets. Replace them after rinsing them thoroughly.
when following it from Step 3 to Step 1, the filter system will be installed.
Then
during a wash cycle
It is dangerous to open the door when washing, because the hot water may scald you.
press this button to reset , Then you can change the progra m to
, the machine will pause. The program light will
4 Add forgotten dishes.
5
Close the door
Press the Start/Pause Button
6
after 10 seconds.
running indicator will
, the dishwasher will run