Change The Program; Forgot To Add A Dish; At The End Of The Wash Cycle - Omega TDX7SS-5 Instruction Manual

NOTE: NOTE:
When you press the Start/Pause button to pause during washing, the LED display window
will stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.

Change the Program

Change the Program
Premise:
1 A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
In this case, the detergent dispenser must be refilled (see the section entitled " Detergent " ).
2 Press the Start/Pause button, the machine will be in standby state, press the program button more than
3s then you can change the program to the desired cycle setting (see the section entitled " Starting a wash " )
The LED display shows the state of the dishwasher:
a) The Screen shows H MM and the
b) The Screen shows H MM and the
NOTE: NOTE:
If you open the door during a wash cycle , the machine will pause.
window
close the door . After you the machine will keep on working after 10 seconds.

Forgot to Add a Dish

Forgot to Add a Dish
A forgotten dish can be added any time before the detergent cup opens.
1
Press the Start/Pause Button to stop the washing.
2
Open the door a little .
3 After the spray arms stop working, you can open the door
completely.

At the End of the Wash Cycle

At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid scald the dishes and utensils
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The Led screen is on but the colon icon is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
NOTE: NOTE:
Wash the arms in soapy and warm water and use a soft brush to
When following this procedure from step1 to step 3, the filter system will be removed;
WARNING! WARNING!
clean the jets. Replace them after rinsing them thoroughly.
when following it from Step 3 to Step 1, the filter system will be installed.
colon icon
colon icon
will stop blinking and the buzzer will mooing every minute unless you
It is dangerous to open the door when washing, because the hot water may scald you.
not blinking------------------Stand by or Being paused
blinking-----------------------Running
Add forgotten dishes.
4
5
Close the door
Press the Start/Pause Button, the dishwasher will run
6
after 10 seconds.
9 9
the LED display