Operation - Viking E-10-IP Product Manual

A. "CALL" Button
When the "CALL" button is pressed, the E-10/20/30-IP phone dials a pre-programmed telephone number. The
Call Connected LED momentarily flashes during dialing. In the event the line is busy or there is a ring-no-answer,
the unit can be programmed to call additional phone numbers.
The phone then cycles through up to 5 pre-programmed numbers until the call is answered. When the call is an-
swered, the phones are factory programmed to automatically light the "Call" LED to show that handsfree com-
munication to personnel is established. Once the "Call" LED is on, the # key can be used to force the phone to
hang-up.
C. Remote Access Operation Commands
Feature
Activate
Relay
Un-Latch
Relay
Latch
Relay
Disconnect
Send ID and Play
Message
* Note: Latching commands must be enabled (Q6) in programming.
10

Operation

Tone Tone
Description
Command
QQ or
Momentarily activate relay (1 or 2 digits, factory set to QQ).
___ ___
Q0
Un-latch* (deactivate) the relay.
Q1
Latch* (continuously activate) the relay.
# Disconnects or forces the emergency phone to hang up.
Q
Send I.D. number (if programmed) and plays the announcement.