Installation - Viking E-10-IP Product Manual

IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
A. Mounting the E-10-IP, E-10-IP-EWP, E-30-IP and E-30-IP-EWP
The E-10-IP and E-30-IP are designed to be flush mounted to the included 4" x 4" x 2" deep plastic rough in box
or surface mounted using an optional Viking model VE-5x5. Note: The E-10-IP and E-30-IP will NOT mount to a
standard double gang box. The plastic rough in box (part # 259576) may be purchased separately. Go to
www.vikingelectronics.com and click on "Spare Parts".
Front View of Plastic
Rough-In Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
5.22"
5.14"
Front View of Optional
2.25"
VE-5x5 (not included)
B. Mounting the E-20-IP and E-20-IP-EWP
The E-20-IP and E-20-IP-EWP are designed to be surface mounted to a single gang box (not included), a standard
4" x 4" electrical junction box (not included), or directly to a wall or flat sided post. Caution: For rough surfaces
(ie: brick, stucco, etc.) additional caulking may be required.
3.40"
1.55"
3.30"
3.40"
2.35"
* Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire
with a maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.
4
4.0"
3.25"
(1) .74" dia
Condensation
Drain Hole
Rear View of VE-5x5 (not included)
Front view of the
E-20-IP/E-20-IP-EWP
Call
VIKING
©
To open the speaker box, remove the
two separate screws from the cover.

Installation

2.1"
*
1/8" thick foam
gasket (included)
Typical
Push to Call Button
(4) 6-32 X 3/4" stainless steel, flat
head, hexdrive, screws (included)
Condensation Drain Hole
(4) 0.38" diameter (for gooseneck mounting)
(4) 0.2 x 0.43 slots for double gang box
(2) 0.2 x 0.43 slots for single gang box
3.0" 3.3"
3.0"
Back Panel of the
E-20-IP/E-20-IP-EWP
UP
Mount back panel to a wall, a single
gang box or a 4"x4" junction box with
the arrow pointing up. Note: For
outdoor applications apply a bead of
caulk between back panel and wall.
* Note: Peel off paper liner and
adhere gasket to the back of the
faceplate, centering it over the four
corner mounting holes.
Caution: For rough sur-
5.0"
faces (ie: brick, stucco,
etc.) additional caulking
may be required.
The optional VE-5x5 Surface Mount Box is de-
signed to be surface mounted to a single gang box,
double gang box or VE-GNP gooseneck pedestal
(shown right). For more information on the VE-5x5
and VE-GNP, see DOD# 424.
Side view of the
E-20-IP/E-20-IP-EWP
Attach the cover to the
base with the two included
screws as shown.