Switching The 75-Ohm Terminate Connectors (Vph-G90M/G90U Only) - Sony VPH-G90E Installation Manual

Switching the 75-ohm Terminate Connectors
(VPH-G90M/G90U only)
Depending on the connections of the computer and color monitor to the
projector, it may be necessary to switch the 75-ohm terminate connectors
on the BA board at the rear of the projector.
1
Loosen the ten screws at the rear of the projector to remove the
connector panel.
2
Disconnect the CN351 connector from the BA board.
CN351
(continued)
27
Connections (GB)