Sony VPH-G90E Installation Manual page 47

4 RGB keys
Adjust the picture.
APA: This key does not function with this projector.
DOT PHASE: This key does not function with this
projector.
SIZE: Enters the size adjustment mode for the input
signal. Next adjust the size of the picture using the
four arrow keys. Each time you press this key, the
COARSE and FINE modes are switched
alternately.
B: to reduce horizontal size
b: to expand horizontal size
V: to expand vertical size
v: to reduce vertical size
SHIFT: Enters the shift adjustment mode for the input
signal. Next adjust the position of the picture
using the four arrow keys. The picture shifts in the
direction of the arrow on the pressed key. Each
time you press this key, the COARSE and FINE
modes are switched alternately.
5 COMMAND ON/OFF switch
No keys on the remote commander except the LIGHT
button 1 function when this switch is set to OFF. This
saves battery power when a button is pressed
inadvertently.
6 CENT R/B keys
Enter the centering adjustment mode of the red and
blue.
R: Press to enter the red centering adjustment mode.
B: Press to enter the blue centering adjustment mode.
Perform the centering adjustment using the four arrow
keys.
7 MEMORY key
Stores various adjusted data into memory.
8 ON/SYANDBY keys
Turn on and off the projector when the MAIN
POWER switch on the projector is set to ON.
9 MENU key
Displays the main menu. Press it again to turn off the
menu.
0 Arrow keys
Adjust the value or select the item in the menu.
!¡ ENTER key
Stores the settings in the menu, or selects and displays
the index number.
!™ FUNCTION key
Press to use the extended functions.
!£ RESET key
Resets the adjusted levels to the factory preset or
service adjusted levels.
For details, see page 138
(GB)
!¢ POSITION +/– keys
Select the position to be adjusted on the screen in
focus, registration or blanking adjustment mode.
Also, set V SHIFT to WIDE or NARROW in RGB or
HDTV input signal's SHIFT adjustment mode and
select the color temperature in white balance
adjustment mode.
!∞ PICTURE CONTROL keys
Adjust the picture conditions: CONTR (contrast),
BRIGHT (brightness), COLOR, HUE and SHARP
(sharpness).
!§ VOL (volume) +/– keys
These keys do not function with this projector.
!¶ MG FOCUS key
Enters the magnetic focus adjustment mode.
For details, see "Adjusting the green magnetic focus, AQP/
DQP and AHP/DHP" on page 87
!• FOCUS LENS key
This key does not function with this projector.
!ª POSITION +/– keys
Function the same as the POSITION +/– !¢ keys.
@º W/B (white balance) keys
Enter the white balance adjustment mode.
BIAS: Adjusts cut off.
GAIN: Adjusts drive.
@¡ REGISTRATION keys
CENT/SIZE/LIN/SKEW/BOW/KEY/PIN/ZONE
Select the desired item for registration adjustment with
each key, then adjust the item with the arrow keys.
You can switch FINE or COARSE adjustment mode
or select the adjustment postion with some of these
keys.
For details, see "Adjusting the Registration" on page
93 .
(GB)
.
.
(GB)
47
Before Adjustment (GB)