Sony VPH-G90E Installation Manual page 41

Connecting the PC-1271/1271M using the 5BNC cables (5BNC mode 2)
TRIGGER
VIDEO IN
to video output
Video
equipment
* For the VPH-G90E model:
IFB-G90E Video Interface Board (optional)
When the PC-1271/1271M switcher to be connected is more than 50 m
away from the projector, or the SIC-M or CCQ-BRS cable cannot be used
for the connection between the projector and switcher, connect the RGB
signal sources to the switcher and the video signal sources to the projector.
*
IN OUT
R
IN OUT Y IN C IN
R-Y/P
IN OUT
VIDEO S VIDEO
LINK VIDEO
IN OUT
RS-232C/422A
RS-232C RS-422A
PLUG IN POWER
CONTROL S DEVICE INDEX
S VIDEO IN
CONTROL
S IN
Remote
control cable
(supplied)
to S video output
to CONTROL S
OUT
15 K RGB/HD/
Component
equipment
Setting up
• Set INPUT-A in the SET SETTING 1 menu
5BNC MODE in the SERVICE SETTING 1 menu
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control.
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• When the HDTV signal is input to the switcher, set the output of the
connected equipment or the IFB-1301 Signal Interface Board installed to
the switcher to GBR OUT.
• When the component signal is input to the switcher, set the output of the
connected equipment or the IFB-1200 Signal Interface Board installed to
the switcher to RGB OUT.
Rear
AC IN
G B SYNC/HD VD
Y B-Y/P
R B
INPUT A
IN PJ COM OUT
REMOTE
INPUT A
5BNC cables
to MONITOR OUT
PC-1271/1271M
Switcher
Computer
AC power cord (supplied)
to a wall outlet
Ç Signal flow
Computer
to RGB and
(page 62 )
(GB)
to ON.
(page 69 )
(GB)
Connections
41
(GB)