For Remote Control; Preparation Of The Remote Commander - Sony VPH-G90E Installation Manual

For Remote Control

Preparation of the Remote Commander

42
(GB) Before Adjustment
Before Adjustment
All adjustments, except focusing the lens and adjusting the scheimpflug,
can be made with the supplied remote commander.
Since the remote commander uses infrared, you can use it without a wire.
However, in order to correctly control the projector, you should connect
the remote commander to the projector with the supplied remote control
cable.
Normally, the remote commander is set to the user mode and the
adjustment keys on the remote commander are inoperable to prevent
accidental adjustments. Cancel the protection before adjusting.
1
Insert the three supplied R6 (size AA) batteries with the polarities lined
up correctly.
For details, see "Battery installation" on page 44
2
Connect the remote commander to the projector.
See "Connecting the remote commander to the projector" on page 45
3
Make sure that the COMMAND ON/OFF switch on the remote
commander is set to ON.
4
Turn on the MAIN POWER switch on the projector, and then press the
ON key on the remote commander.
5
Open the panel cover of the adjustment keys.
.
(GB)
.
(GB)