Installation Planning; Installation; Unpack Appliance; Fit Standoffs - Valor 1500INO Installation & Owner's Manual

L1 series dv zc gas fireplace for outdoor use

Hide thumbs Also See for 1500INO:

Installation & owners manual (58 pages)

Table Of Contents

Table of Contents

QUALIFIED

INSTALLER

Installer—READ THIS FIRST

Only qualiﬁ ed licensed or trained personnel

should install this appliance.

1. YOU NEED TO KNOW FROM THE

HOMEOWNER:

- The height of the unit and hearth if used;

- The thickness and type of the wall ﬁ nish

around the ﬁ rebox opening;

- What accessories (trim, etc.) will be installed

with this ﬁ replace;

- The venting conﬁ guration.

2. Unpack the appliance, removing all items packed

inside and around the appliance.

3. Check that you have everything, using the Pack

Content sheet. Also, check that you have:

◊ a fuel bed (packed separately)

◊ a set of liners (packed separately)

4. Finish the framing.

Unpack Appliance

Beware of sharp edges! Wear gloves!

1. Remove the cardboard wrapping and the wood

pallet from the appliance and discard.

2. Unpack any loose items from around the appliance.

3. Remove the window and set aside in a safe place to

avoid damage—see next page.

4. Verify that you have all the components required

for the installation, including:

◊ approved cement board;

◊ liners and fuel bed (in separate cartons);

◊ trim kit with barrier screen;

◊ venting components and accessories.

Fit Standoffs

The standoffs are supplied ﬂ at on the ﬁ rebox sides and

ﬁ xed at one end. Swivel up the ﬂ at standoffs, bend

them as shown and ﬁ x the loose end to the top of the

ﬁ rebox.