Programming Worksheets; Entering Programming Mode - Secutron MR-2602 Installation Manual

MR-2602 Installation & Operator's Manual

8.0 Programming Worksheets

8.1 Entering Programming Mode

Please see "6.0 Programming the MR-2602 System" on page 22 for complete instructions.
All zone alarms must be reset prior to entering the programming mode. While the panel is in the
Note:
programming mode, the annunciators will show a trouble condition.
To enter the Programming mode:
1. Press and hold the Walk Test button for two seconds (located behind the display PCB).
2. Press any button to turn off the trouble buzzer.
3. Press Silence Alarm to scroll through the settings for each programming section (e.g. to change the zone
type, or to turn an option on or off).
4. Press Silence Trouble to move to the next programming section (e.g. to move from zone 1 to zone 2).
5. The panel will indicate the current programming section using the Common Trouble LEDs, as shown
below.
Please see "6.2 Programming Section Descriptions" on page 24 for detailed descriptions of each
programming section.
30