Advertisement
ST40•15 (flush) black
Mount the housing with two M4x8 flathead screws. Keep the inside of the housing
Battery box ST50•65
Remove the protective layer from the adhesive ring on the back of the keypad unit.
Position the keypad and press it into the housing. Make sure the surfaces are dry
and clean, and no cables are in the way. Do not remove and re-apply keypad
once it has been glued in the housing!
Connect one (1) battery to the battery box. Only use DURACELL PROCELL 9V-
ALKALINE- or Energizer batteries.
Dimensions of the battery box:
Vlijtstraat 40, NL-7005 BN Doetinchem
Tel: +31 314 376 876 Fax: +31 314 376 878
www.m-locks.com / info@m-locks.com
clean (remove dust). Route the cable through the cable hole.
Route the battery cable in the opposite direction through the
cable hole and push the white connector into the receptacle
on the circuit board. Make sure the connector is completely
seated.
ST40xx Technical Manual
Advertisement
