Indicator Lights; Installing The Appliance - IAG IOE6SE1 Manual

Installation & Operation Manual for 600mm Multifunction ovens

INDICATOR LIGHTS

The indicator lights situated above the control panel go on and off when the heating elements are
inserted or removed. During the thermostatic functioning of the oven, the neon light remains on until
the pre-chosen temperature is reached and when it goes out, this is a sign that the temperature has
been reached. When the oven cools, the thermostat determines the re-insertion of the heating
elements with consequent re-lighting of the indicator lights. In models the internal oven light, which
is always on when any function is in operation, is considered as an operation, is considered as an
operating warning light.

INSTALLING THE APPLIANCE

Important: Unplug your oven before performing installation or maintenance!
Installation should be carried out according to the instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to
a wrong installation.
FITTING THE APPLIANCE
Fit the appliance into its surround (beneath a
work-top or above another appliance) by
inserting screws into the 4 holes that can be seen in the frame of the oven when the door is open.
For the most efficient air circulation, the oven should be fitted according to the dimensions shown in
fig. 1-2 of page 2.
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which
the oven is fitted should have a gap of at least 70 mm at the rear.
NB: where ovens are to be matched with hobs, it is essential to follow the instructions contained in
the booklet supplied with the other appliance.
IMPROTANT
During use the appliance becomes hot, Care should be taken to avoid touching heating elements
inside the oven.
Accessible parts may become hot during use. Yong children should be kept away.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they
can scratch the surface, which may result in shattering of the glass.
For a built-in oven to work well the cabinet must be of the right type.
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature of
120 . Plastic materials or adhesive which cannot withstand this temperature will become deformed
or unstuck.
To comply with safety regulations, once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
All parts which offer protection should be fixed in such a way that they cannot be removed without
the use of a tool.