Installing The Appliance; Indicator Lights; Fitting The Appliance - IAG IOE6SE2 User Manual

INDICATOR LIGHTS

The indicator lights situated above the control panel go on and off when the heating elements
have reached the selected temperature, the lights go on and off as the elements are cycling.
During the thermostatic functioning of the oven, the neon light remains on until the pre-chosen
temperature is reached and when it goes out, this is a sign that the temperature has been reached.
When the oven cools, the thermostat determines when the heating element switches on again to
bring the oven back to temperature the indicator light will come again. In some models the internal
oven light comes on when any function is in operation.

INSTALLING THE APPLIANCE

Important: Disconnect your oven before performing installation or maintenance!
Installation should be carried out according to the instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to
a wrong installation.

FITTING THE APPLIANCE

Fit the appliance into its surround (beneath a
work-top or above another appliance) by
inserting screws into the 4 holes that can be seen in the frame of the oven when the door is open.
For the most efficient air circulation, the oven should be fitted according to the dimensions shown in
fig. 1-2 of page 2.
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which
the oven is fitted should have a gap of at least 70 mm at the rear.
NB: where ovens are to be matched with cooktops, it is essential to follow the instructions contained
in the booklet supplied with the other appliance.
IMPORTANT
During use the appliance becomes hot, Care should be taken to avoid touching heating
•
elements inside the oven.
Accessible parts may become hot during use. Yong children should be kept away.
•
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass
•
since they can scratch the surface, which may result in shattering of the glass.
For a built-in oven to work well the cabinet must be of the right type.
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature of
120℃. Plastic materials or adhesive which cannot withstand this temperature will become deformed
or unstuck.
To comply with safety regulations, once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
All parts which offer protection should be fixed in such a way that they cannot be removed without
the use of a tool.
Installation & Operation Manual for IOE6SE2 oven