Using The Turnspit; Fan Assisted Total Grill; Lower Heating Element + Fan - IAG IOE6SE1 Manual

Fig.6
Using the turnspit (NOT AVAILABLE ON ALL MODELS)
In the "CONVECTIONAL OVEN" models, the turnspit can be used in combination with the grill. After
fitting the food on to the spit S, block it with the two forks F. then proceed as follows:
Fit the knobs protection as shown in (fig. 6)
-
Position the spit support as shown in (fig.7)
-
Fit the end of the spit into the motor M at the back of the oven (fig. 7).
-
Fit the support into the circular groove in the spit.
-
Unscrew and remove handle A.
-
Place the oven tray with a little water on the lowest shelf of the oven.
-
Turn the knob to position
-
Partially close the oven door (fig. 6b).
-
When the cooking time is up, screw the handle on the spit and remove everything from the
-
oven. If necessary, use an oven glove to avoid any burn.
Installation & Operation Manual for 600mm Multifunction ovens

Fan assisted total grill

The air which is heated by the grill heating element is
circulated by the fan and so helps to distribute the heat
50 - MAX
between 50 and 200 . This function can be used for
sterilizing glass jars.

Lower heating element + fan

The air which is heated by the lower heating element is
50 - MAX circulated by the fan and so helps to distribute the heat
between 50 and 200 . This function can be used for
sterilizing glass jars.
upper heating and inside hearting Series + lower heating
element
This function Used multibarreled has also worked, in the
50 - MAX
gallbladder gave off heat evenly, the enrgy consumption
was low
to start up the motor.
Fig.7